You can find the instructions in the attachment as a PDF and here.
Replacement of the Overheating Protection Device (Part No. 0119017):
The replacement may only be performed by the manufacturer or a qualified electrician.
Danger:
Improper replacement may impair the operation of the overheating protection.
Fire hazard due to overload.
Risk of electric shock if not installed properly.
Attention:
Do not apply mechanical stress to the cover cap of the overheating protection device, as this may impair its function. Do not continue to use overheating protection devices with visually damaged cover caps.
The performance values specified on the nameplate of the cable bearing used must be observed and must not be exceeded when the cable is in its unwound state.
Instructions:
Unplug the power cord / Disconnect the cable reel from the power source.
Unscrew the outlet plate (3 screws).
Unscrew the two screws securing the wires to the overheat protection device (2 screws).
Removing a defective overheating protection device:
By prying or bending the overheating protection device out of the red sleeve that is built into the outlet plate, for example, using a screwdriver. This will inevitably damage the overheating protection device.Push the old sleeve from the inside out and remove it.
Insert the new sleeve into the outlet plate (for IP 44, you must also slip on the protective cap provided).
Press the overheating protection into the sleeve. When doing so, make sure that the small tab on the outside of the push button is inserted into the groove in the sleeve.
Press the overheating protection firmly into the sleeve until it clicks into place. Then join the two parts together to form a single, secure unit.
Screw the two wires in place and reattach the outlet plate using the three screws.
Disclaimer:
The manufacturer assumes product liability only for products in which the overheating protection element has been replaced by the manufacturer.